The Grappler Sidekick Pro Flux Carbon GR Enduro wheels standing on gravel among autumn leaves, teal rim tape showing. Photo: Pinkbike
Reviews

Pinkbike Gives Grappler Flux Carbon a Thumbs Up

Matt Beer found them compliant but not too noodly, and less tiring on long descents.

Between Laps 4 min read

Matt Beer found them compliant but not too noodly, and less tiring on long descents.

Matt Beer, Pinkbike's tech editor and a two-time Canadian national downhill champion, reviewed our Grappler Sidekick Pro Flux Carbon GR Enduro wheels and gave them a thumbs up. His set was a mixed-wheel build: a 29" front on a Flux 54 carbon rim, a 27.5" rear on a Flux 66 GR, 30mm inside at both ends, with Sidekick Pro hubs.

A different rim at each end

Our front and rear Flux rims use different carbon layups, because the two wheels do different jobs. His pros list opens on it: "Unique front and rear carbon rim layups let the front and rear wheels act accordingly." On the trail, he could feel the split.

"The front has a soft, calm ride to it, while the rear is solid without being harsh," he writes. He never felt his bones being shaken on rocky trails, holding off-camber lines wasn't a problem, and after rock strikes he didn't notice sharp forces or pings shooting through to his hands or feet.

The Flux 54 front rim and Flux 66 GR rear rim, side by side on gravel. Photo: Pinkbike

He calls the compliance admirable, and says the wheels "aren't too noodly or spit you out of corners unexpectedly." His test bike was a Santa Cruz Nomad V6, which he describes as sturdy, and he found the Grappler Flux rims "more compliant than most" on it. He notes that carbon rims are generally stiffer than alloy. On ours, his comparison went the other way: "they're actually quite comparable to some alloy wheels."

Descending long enduro tracks is less fatiguing with the Grapplers, and they've held up to some poor line choices along the way.

Matt Beer, Pinkbike

Sidekick Pro hubs

He set the deadband by hand. Pull the wheel, unthread the hub end caps, and move the pusher to the 9, 13 or 18 degree mark. The cassette stays on and no tools are needed, which he says makes it easy enough to change in the field and feel the difference on back-to-back laps.

A Sidekick Pro rear hub with the freehub pulled back to show the red pusher and its deadband marks. Photo: Pinkbike

On the trail: "Yes, there is a noticeable change to mitigate chain feedback, even in the 9-degree deadband position." He expects most enduro racers to choose 9 degrees, for technical climbing, unless the course is seriously rough.

The hubs worked flawlessly through the whole test. At the end, he looked inside:

Inside, the grease still looks new, and they're rolling as smoothly as they did on day one.

Matt Beer, Pinkbike

Setup and upkeep

The wheels arrived with rim tape and valves fitted. Maxxis and Michelin tires mounted and inflated with no dramas.

The factory-fitted teal tubeless tape and valve inside a Grappler Flux carbon rim. Photo: Pinkbike

He also covers the warranty. Pinkbike lists the rims under the wheel and rim part of our Infinite Ride warranty: carbon rims are covered for the life of the product for the original owner, however the rim failed. Hub bearings are replaced free for life, and the rest of the hub carries ten years.

The two cons, and our answers

His cons list has two lines: the wheels aren't as light as some competitors, and a few nipples or spokes were difficult to turn when truing.

Weight. His set weighed 2,035g, 909g front and 1,126g rear. He answers part of this himself: "I'd take a heavier, more compliant carbon rim over a brittle, brutal one."

The extra grams aren't in the hub. Pinkbike lists the Sidekick Pro rear hub at 300g, 10g more than an Industry Nine Hydra 2 in the same 12x148 XD spec. They're in the rear rim, on purpose. A 27.5" rear on a mixed-wheel bike takes the hardest hits, so the Grappler set builds it on the Flux 66 GR, the rim in our Grappler DH wheels, which have raced several World Cup seasons. A 29" rear is built on the Flux 55, and our spec weight for that wheel is 60g under the 27.5". That strength is also what lets us cover every carbon rim for life, however it breaks.

Stiff nipples. The wheels are built with Sapim Secure Lock brass nipples. Sapim presses a small, precise deformation into the nipple thread, a locking system that stops the nipple from loosening on its own. A spoke key has to turn against that lock too, so these nipples feel stiffer on the truing stand than plain ones. We spec them so the tension stays where the wheel builder set it. If you true them at home, use a spoke key that fits the nipple flats closely, so the flats don't round off under the extra torque.

Our take

The alloy comparison is the part we'd point to. The aim for Flux carbon was a rim with the give of an alloy one, lighter and stronger than alloy, and a reviewer measuring ours against most carbon wheels put them close to alloy.

The front-and-rear split is the other half of that aim, and he felt it without being prompted: a calm front, a solid rear.

He also notes the hubs haven't been through a full winter of bike washing yet. That's the season that tests hub bearings, and ours carry free replacement for life.

Read the full review at Pinkbike

The Grappler Sidekick Pro Flux Carbon GR Enduro front and rear wheels are €1,899.90 a set, in 29" or mixed-wheel sizes.

Photos: Pinkbike, from Matt Beer's review.

Shop the Sidekick Wheels collection
Sidekick Wheels
Collection · 31 products Sidekick Wheels Shop the collection
Share Link copied